Wilson Pickleball Net

The Wilson Pickleball Net is the only pickleball net that works with the Wilson Pickleball Posts. This net has specially-designed hooks that are compatible with the unique crank system found only on the Wilson Posts. This net is meant for use with permanent, in-ground posts. The heavy-duty material promises to stand the test of time. However, while this net is made from resilient products, it can get damaged if introduced to extreme weather conditions or left outside for extended periods of time.

The Wilson Pickleball Net is comprised of intertwining black 3 mm braided polyethylene. This is an extremely tough material. The top ridge of the net is hugged by a white 23-ounce vinyl headband, which protects the integrity of the net. A steel cable runs inside this band, and attaches to the Wilson Poles. A 1/2” diameter fiberglass dowel slides through pockets on the two sides of the net to maintain its shape.

The Wilson Pickleball Net is the official pickleball net size of 21' 9" feet wide and 31 inches high. This net will allow for space to roll balls underneath net.

Shipping Information: This item will be drop-shipped from the manufacturer. You will receive separate tracking numbers if you have other items in your order. Ships via UPS.

RETURNS: A 10% restocking fee will be charged on all returned nets. (This does not apply to nets returned due to defects or warranty issues).

Wilson Pickleball Net
Official size: 21' 9" L x 31" H (when set at 34" height in center, there will be a gap underneath for passage of balls)
3 mm braided polyethylene
23 oz vinyl headband
27' steel cable (+/- 2")


Installing Pickleball net on posts
Begin installing your net by connecting the loop end of the net cable to the post cleat. Take the other cable loop and hook it into the pin on the crank assembly and begin winding. Continue to crank the post so that the net is at 34” at the center of the court.Fit Dowels/side stakes into the side pockets of the nets.Install lacing cord at each end by making a 2” knotted loop on one end of the lacing cord. Run the other end through both grommets in the headband and around the post through the 2” loop and back around the post in the opposite direction. Continue wrapping the cord around the post, tie off the cord at the bottom of the post. Repeat for the other post.When you are finished the net should be fully extended so that it completely fills in the space between the two posts. During the off-season or when winterizing your courts, remove the net.Your installation is now complete and your net should sit comfortably but somewhat tightly between the two posts with a very small gap between the net and net posts